What protocols are supported?
| Protocol | Binho Supernova | Binho Pulsar | Binho Atira | Binho Nova (legacy) |
|---|---|---|---|---|
| I3C | Controller and target, incl. HDR-DDR | No | No | No |
| I2C | Controller and target | Controller and target, two separate buses | No | Controller |
| SPI | Controller and target | Controller and target | Controller, with SPI flash programming | Controller |
| UART | Yes | Yes | USB-to-UART bridge | Yes |
| GPIO | Yes | Yes | No | Yes, plus ADC, DAC and PWM |
| RS-485 | No | Yes, through the USB serial port | No | No |
| CAN-FD | No | Yes, through the USB serial port (SLCAN) | No | No |
| 1-Wire | No | Yes, in Nova compatibility mode | No | Yes |
| Atmel Single-Wire | No | No | No | Yes |
| SWD debug | No | No | Yes | No |
Supernova and Pulsar notes
- RS-485 and CAN-FD are modes of the adapter’s USB serial (CDC) port. Select the mode with CosmicSDK or PyCosmicSDK (
Device.set_usb_config()); the adapter resets and the setting persists across power cycles. Then open the serial port in a separate tool: CAN-FD uses the SLCAN protocol. - What each adapter supports from software: PyCosmicSDK and CosmicSDK.
See the Hardware Comparison Table:

