binhosupernova
binhosupernova is the Python package for the Binho Supernova USB host adapter. It is the lower-level of the two Supernova Python packages: SupernovaController is built on it and installs it as a dependency, alongside transfer_controller.
SupernovaController is the usual starting point, with a blocking API over the Supernova’s asynchronous interface. binhosupernova is for work closer to the device. The manual firmware flashing procedure in Updating Firmware uses it directly.
Requirements
Section titled “Requirements”- Python 3.8 or higher
- A Binho Supernova host adapter
Installation
Section titled “Installation”pip install binhosupernovaThe latest release is 4.2.0 (11 June 2025), which added I3C HDR-DDR mode with private write/read transfer methods, persistent voltage configuration across power cycles for I2C, SPI, UART, and GPIO, and unified I2C pull-up resistor values between the Supernova and Pulsar platforms.
https://pypi.org/project/binhosupernova/

