I3C Target Board
Binho I3C Target Board.
The I3C Target Board holds Bosch and STMicroelectronics evaluation boards, to test their I3C target devices with a Binho Supernova. The evaluation boards are not included: buy them separately.
Product page and ordering on binho.io
What it holds
Section titled “What it holds”| Socket | Evaluation boards | Target devices |
|---|---|---|
| Bosch Shuttle 3.0 | Bosch Shuttle 3.0 boards | BMI323, BMM350, BMP581, BMP585, BMA530, BMA580 |
| STMicroelectronics DIL24 | ST DIL24 boards | LPS22HH, LSM6DSV, LSM6DSV16B, LSM6DSV16BX, LSM6DSV16X, LSM6DSV32X, LPS28DFW, ILPS28QSW, LIS2DUX12 |
What is on the board
Section titled “What is on the board”- Two sockets: one for a Shuttle 3.0 board and one for a DIL24 board. Both can be fitted and used at the same time.
- Headers: standard 2.54 mm headers expose all the I3C target pins.
- Logic analyzer headers: on the SCL and SDA signals, for bus monitoring. Connect a logic analyzer to capture the traffic.
- Daisy chain: the I3C bus passes through the board, so several devices can be connected in series.
- Power jumpers: select external power or power from the Supernova.
Connect it
Section titled “Connect it”- Fit the evaluation board in its socket.
- Set the power jumpers: external supply, or the Supernova’s.
- Connect the board to the Supernova’s I3C port.
- Open the Supernova in Mission Control 3 or PyCosmicSDK and scan the I3C bus.
I3C on the Supernova, and the voltage of its I3C ports: Protocols and Hardware Reference.