Command Panel
The Command Panel sits between the Navigation Menu and the Transaction Log View. It is where commands are entered for devices on the bus, and its options change with the selected protocol.
The tour below configures and runs transactions with an accelerometer on a Binho Supernova.
The example steps:
- Initialize the bus by clicking the “INIT BUS” button.
- Select the accelerometer sensor, identified by the address 0x08.
- Set the push-pull clock to 12.5 MHz, the maximum I3C frequency.
- Adjust the bus voltage to 3.3 V.
- Read 10 bytes.
- Run two CCC requests: GETBCR and GETMWL.

