Binho Supernova: Troubleshooting
Find the symptom, then open the page. The steps are the same for the Supernova and the Pulsar.
| Symptom | Page |
|---|---|
| The adapter stops answering, times out, or resets itself | Adapter Stops Responding |
| The adapter shows up as a USB drive or as “bootloader”, or a firmware file is rejected | Firmware and Bootloader |
| The adapter is not found on Windows or macOS, or a Zadig driver broke it | Windows and macOS |
| The adapter is not found on Linux, or its serial number is empty | Solving USB Connection Issues on Linux |
| mc3.binho.io does not see or keep the adapter | Mission Control 3 in the Browser |
Specific to the Supernova
Section titled “Specific to the Supernova”- In bootloader mode the adapter mounts a USB drive named SUPERNOVA. See Firmware and Bootloader.
- Firmware for the Supernova is named
supernova-app-<version>.afx. See Firmware. - Mission Control 2.16.1 and earlier do not work with Supernova firmware 4.x. Use Mission Control 3.
- On Linux the Supernova needs a
udevrule, installed once. See Solving USB Connection Issues on Linux.
Still stuck? Collect the details listed in Collect Information for Support and email [email protected].
Known Limitations
Section titled “Known Limitations”- One role at a time. I3C, SPI and I2C each run as a controller or as a target, but not both at the same time.
- I3C SDR frame limit is 32,767 bytes, register address included. Keep frames within that limit; PyCosmicSDK and CosmicSDK enforce it.
- I3C IBI payload is at most 8 bytes, and the target must end the IBI with the T-bit low.
To update the firmware, see Updating Firmware.

