Binho Nova: Protocols
The Nova works with one protocol at a time, at 3.3 V logic. It has 5 signal pins. While a bus uses some of them, the others keep their other functions, for example as chip selects or interrupts.
| Protocol | Role | Limit | ASCII command reference | Mission Control 2 |
|---|---|---|---|---|
| I2C | Controller | Up to 3.4 MHz | I2C Commands | I2C |
| SPI | Controller | Up to 12 MHz | SPI Commands | SPI |
| UART | Up to 1,000,000 baud | UART Commands | UART | |
| 1-Wire | Dallas 1-Wire | 1-Wire Commands | 1-Wire | |
| Single-Wire | Atmel Single-Wire Interface (SWI) | SWI Commands | ||
| GPIO | Input, output, PWM output, interrupt (rising, falling or both edges) | 5 pins, shared with the bus pins | IO Commands | GPIO |
| Analog | 5 ADC inputs, 1 DAC output | IO Commands |
The Nova has no I3C, RS-485 or CAN-FD. For those, see the Protocols and Interfaces comparison, and the Supernova or the Pulsar.
How to drive it
Section titled “How to drive it”- Without code: Mission Control 2.
- From Python: the Nova SDK,
pip install binho. - From a serial terminal: the Nova’s native protocol is the human-readable ASCII Command Set. Any terminal program can drive the Nova, with no code.
ADC and DAC
Section titled “ADC and DAC”The Nova has 5 ADC inputs and 1 DAC output on its signal pins. Use the ADC to read slowly changing (roughly DC) voltages and the DAC as a near-DC test stimulus.

