1-WIRE
1-Wire is a half-duplex protocol that uses one data line plus a ground reference. It is asynchronous: specific timings tell the commands apart. Like I2C, it is open-drain at the hardware level.
.png)
1-Wire command panel
Settings
Section titled “Settings”.png)
Settings sub-panel
This segment can turn on the internal pull-up resistors, if the adapter has them. The Command dropdown lists the ROM commands SKIP and SELECT (also called MATCH). SKIP sends a message to all target devices, and SELECT talks to one specific device. With only one target on the bus, both are ignored. The SCAN button runs a series of SEARCH commands and lists the 64-bit addresses of all targets on the bus.
Transfer
Section titled “Transfer”.png)
Transfer sub-panel
This segment has two inputs, Bytes to Read and Bytes to Write, and three buttons: READ, WRITE and TRANSFER. As with the other protocols, Bytes to Write takes hexadecimal bytes. TRANSFER runs a write, then a read.

