Binho Atira: Firmware
The firmware the Binho Atira needs, how to read the version on the Atira, and how to update it.
Which firmware is needed
Section titled “Which firmware is needed”- Opening a device pack in Mission Control 3 needs Atira firmware 1.1 or later, with Mission Control 3 9.1 or later. See Install a device pack.
Check the firmware version
Section titled “Check the firmware version”With PyCosmicSDK installed, run steps 2 to 4 of Setup. The Atira’s firmware version is printed by the “Identify the Atira” step:
from pycosmicsdk import DebugProbe
with DebugProbe.open() as probe: info = probe.info print(f"Firmware: {info.fw_major}.{info.fw_minor}.{info.fw_patch}")Updating the firmware
Section titled “Updating the firmware”The Atira is updated the same way as the Supernova and the Pulsar, with the same three methods:
- In the browser, with dfu.binho.io (Chrome or Edge)
- By drag and drop
- With PyCosmicSDK
The latest version is in the Latest Firmware table. The Linux udev rule in Setup also covers the Atira bootloader. If the update does not complete, email [email protected] with the Atira’s serial number.

