Skip to content
binho.io (opens in a new tab)Contact Us

Memory Programmer

Mission Control 3 Memory Programmer after reading an EEPROM

Memory Programmer after reading a simulated 256-byte EEPROM

The Memory Programmer reads, writes, erases and verifies EEPROMs.

Connect the adapter as described in Connect a Tool. Config at the top right opens the settings for the bus.

Choose I2C or SPI for the bus the EEPROM is on, and set the bus in Config.

Click Scan. Mission Control finds the EEPROM on the bus and selects it in the chip selector, with its size, page size and address. The chip can also be chosen from the selector.

  • Address Range: where to start, and how many bytes (or Entire chip).
  • Read loads the contents into the hex view on the left, shown as 8, 16 or 32-bit values in little- or big-endian order.
  • Write writes the loaded contents; Write Modified writes only the bytes that changed.
  • Erase fills the range with the erase value (0xFF or 0x00); Blank Check confirms a range is erased.
  • Verify compares the chip with the loaded contents. Verify after write does this automatically.
  • File: load or save the contents as Binary (.bin), Intel HEX (.hex) or S-Record (.srec).