Binho Nova: Hardware reference
Specifications, interfaces and pinout of the Binho Nova.
Specifications
Section titled “Specifications”| Feature | Nova |
|---|---|
| I2C | Controller, up to 3.4 MHz |
| SPI | Controller, up to 12 MHz |
| UART | Up to 1,000,000 baud |
| 1-Wire | Dallas 1-Wire |
| Single-Wire | Atmel Single-Wire Interface (SWI) |
| GPIO | 5 pins, shared with the bus pins; interrupts and PWM |
| Analog | 5 ADC inputs, 1 DAC output (not calibrated, see FAQ) |
| Logic level | 3.3 V, fixed |
| Power out | 3V3 and VUSB pins |
| USB | USB 2.0 Full Speed (12 Mbps), Type-C, USB serial (CDC) |
| Power | From USB, 200 mA at 5 V, 1 W max |
| Other | Programmable RGB status LED, field-upgradeable firmware, aluminum enclosure |
Full electrical data is in the Nova datasheet (rev 1.4). To get it, see Where can I find the product datasheet?
Interfaces
Section titled “Interfaces”- USB Type-C: power and data.
- Wire harness: ends in a female 1.27 mm 2×5 IDC connector: 5 signal pins, one 3V3 pin, one VUSB pin and 3 GND pins.
Pinout Guide
Section titled “Pinout Guide”.png)
Nova pin functions by mode.
To connect the Nova to the board, see Hardware Setup: Binho Nova.