Skip to content
binho.io (opens in a new tab)Contact Us

Mission Control 3 Tools

Mission Control 3 opens each tool in its own tab. Start from the home screen, choose a tool, and connect it to an adapter, an Atira or a simulated device.

ToolUse it to
Serial TerminalTalk to UART devices and serial consoles
I2CScan an I2C bus and read and write I2C devices
I3CInitialize an I3C bus, assign addresses, and run transfers and CCCs (Supernova)
SPIRun SPI transfers on any of the four chip selects
GPIOConfigure pins as inputs or outputs and watch interrupts
Memory ProgrammerRead, write, erase and verify EEPROMs
MCU ProgrammerFlash, verify and erase a microcontroller through the Binho Atira (desktop app)
MCU DebuggerHalt, step and set breakpoints in a microcontroller’s program through the Binho Atira (desktop app)

Every tool connects the same way:

  1. Choose the adapter from the device selector at the top left, then click Connect.
  2. In the web app, click Pair Device first to give the browser access to a real adapter. To try a tool without hardware, pick a simulated device instead: Binho Supernova (SIM) or Binho Pulsar (SIM).
  3. Config at the top right opens the settings for the tool.

Every tool shows the Transaction Log at the bottom: each command sent to the adapter, its data, its result and how long it took. It can be searched, filtered, copied and exported.

The Serial Terminal, the MCU Programmer and the MCU Debugger have their own connect steps, described on their pages.

New to Mission Control 3? See Download & Installation.

New to a bus? Protocol primers: I2C, I3C, SPI, UART.